Usage; Repair And Maintenance - Razor POCKET MOD BELLEZZA Owner's Manual

USAGE

Starting the Pocket Mod Bellezza
Place both hands on the handlebars. Slowly push forward with one
foot and apply the throttle.
Note: Keep both feet on the base and both hands on the handlebars
when product is in motion.

REPAIR AND MAINTENANCE

Turn power switch "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power switch off
Adjusting the Brakes
Tools required: 5 mm Allen wrench
1
To adjust brake cable play,
thread the brake lever adjuster
in or out 1/4 to 1/2 turn until
the desired brake adjustment is
attained. Most adjustments are
complete at this step. If brakes
still needs further adjustment,
proceed to step 2.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
• Secure the unit under repair
• Exercise caution around
exposed parts
2
If the brake has too much
slack, loosen the rear anchor
bolt with a 5 mm Allen wrench
and pull the brake wire tighter.
The distance of the brake wire
between the end of the cable and
the anchor bolt should be between
37 mm and 44 mm.
Stopping the Pocket Mod Bellezza
Release the throttle and apply the brakes.
Note: When coming to a complete stop, place both feet on the ground to
balance the unit.
• Contact Razor customer service
if unsure about any repair or
maintenance
3
If the disc brake is dragging on
the brake pads, use your fingers to
twist the caliper adjuster in either
direction until disc is centered
between pads.
8
WARNING: The brakes
are capable of causing the electric
motor bike to skid the tire throwing
an unsuspecting rider. Practice in
an open area free from obstacles
until you are familiar with the brake
function. Avoid skidding to a stop as
this can cause you to lose control or
damage the tires.
Testing the Brakes. To use
the brakes, squeeze the levers
to increase the pressure on the
brakes. The brake levers are
fitted with a cable adjuster to
compensate for cable stretch and/
or to fine-tune the lever movement
to brake engagement. If brakes
are not engaging properly, follow
instructions for adjusting the brakes.