Tone Generator
Tone generation is used to trace cable runs and locate faults by sound.
Selection of this mode emits a cadence from the Net Prowler through the
connected cable. The tone is detected by a tone tracer probe.
Power on the Net Prowler.
•
Use the left or right arrow buttons to select the tone generator
•
icon and press the enter button.
The Net Prowler will automatically activate the tone generator
•
upon entering the tone generator menu.
Connect your cable to either the RJ45 jack or coax connector located
•
on the top of the Net Prowler.
To switch between network and coax cables, press the coax cable/
•
RJ45 soft key
Press the up or down arrow buttons to select tone cadences 1 thru 4.
•
Press the left or right arrow buttons to select which pin or pair to
•
place the tone.
Use a tone probe alongside the cable or at the end of the cable to
•
hear an audible tone.
/
.
21