Configuration Switch Set "S2"; Rear Card Configuration - Patton electronics 1140RC User Manual

3.1.2 CONFIGURATION SWITCH SET "S2"

The DIP switches on S2 set word length, extended signaling rate,
RTS/CTS delay and V.52 and V.54 diagnostic test. The default settings
are summarized in the table below. Following the table is a description
of all possible S-2 switch settings.
S2 SUMMARY TABLE
Position Function
S2-1 Word Length
S2-2 Word Length
S2-3 Extended Signaling Rate
S2-4 RTS/CTS Delay
S2-5 RTS/CTS Delay
S2-6 Future Use
S2-7 Future Use
S2-8 V.52/V.54 Tests
S2-1 and S2-2: Word Length
Switches S2-1 and S2-2 are set in combination to determine the
word length for asynchronous data.
S2-1 S2-2 Setting
Off On 8 bits
On On 9 bits
Off Off 10 bits
On Off 11 bits
S2-3: Extended Signaling Rate
The setting for switch S2-3 determines the range of variability the
Model 1140RC "looks for" in asynchronous data rates (i.e., the actual
variance from a given frequency level the Model 1140RC will tolerate).
S2-3 Setting
Off -2.5% to +1%
On -2.5% to +2.3%
7
Factory Default
Off
}
10 bits
Off
Off -2.5% to +2.3%
On
}
7 mS
On
-
-
Off Enable
Basic
Extended
S2-4 and S2-5: RTS/CTS Delay
The combined settings for switches S2-4 and S2-5 determine the
amount of delay between the time the Model 1140RC "sees" RTS and
when it sends CTS. Options are no delay, 7 ms and 53 ms.
S2-4 S2-5 Setting
On On 7 mS
Off On 53 mS
On Off No delay
Off Off No delay
S2-8: V.54 Loopback Test Enable
To reset the V.54 circuit, set switch S2-6 to the "ON" position, then
back to the "OFF" position..
S2-8 Setting
Off V.54 Enable
On V.54 Disable

3.2 REAR CARD CONFIGURATION

The Model 1140RC is compatible with two dual-fiber interface cards,
one with dual ST connectors and one with dual SMA connectors. Both
cards use an HD-26 female for the RS-232 interface. The single
configuration jumper (JB1) functions identically on both cards. Figure 3
(below) shows the jumper's location.
Figure 3. Model 1140RC rear card jumper location
8
JB1
(pin 1 on left)