Carrier 40UV Installation And Service Instructions Manual page 33

(SEE NOTE 5)
NOTES:
1. Not all components shown for clarity.
2. This drawing applies to 2000 cfm units only.
3. Remove shaft, motor and coupling prior to removing bearing.
Refer lo Removal and P,e_nstaLlat_n instruotio,_s.
4. Install sleeve bearing with oil cup facing up and towards the rear of
the assembly.
5. Refer to Fig. 9 for motor-coupling and shaft-coupling toferances.
(SEE
NOTE
4)
• _ ^*
®
LEFT SIDE
VtEW
Fig. 13 -- 40UH200 Ventilator Blower Drive Train Assembly
UNrT
BOTTOM
33