Compliance And Trademarks; Fcc Notice; Fcc Requirement - Patton electronics 2192 User Manual

1.0 COMPLIANCE AND TRADEMARKS

1.1 FCC NOTICE

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient of relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
This unit was tested with shielded cables on the peripheral devices.
Shielded cables must be used with the unit to insure compliance. This
statement can be deleted if unit was not tested with shielded cables.
The manufacture is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifica-
tions could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference that may cause undesired
operation.

1.2 FCC REQUIREMENT

This equipment complies with Part 68 of the FCC Rules. On the base
unit of this equipment is a label that contains, among other information,
the FCC Registration Number and Ringer Equivalence Number (REN)
for this equipment. If requested, this information must be given to Tele-
phone Company.
3