Mitsubishi Heavy Industries FDT28KXE6A Service Manual page 183

⑤ Function Setting by Remote Controller
The functional setting.
• The initial function setting for typical using is performed automatically by the indoor unit connected, when remote controller and
indoor unit are connected.
As long as they are used in a typical manner, there wiil be no need to change the initial settings.
If you would like to change the initial setting marked "
The procedure of functional setting is shown as the following diagram.
[Flow of function setting]
Start : Stop air-conditioner and press "
" " (MODE) buttons at the same time for over three seconds.
Finalize : Press " " (SET) button.
Reset : Press " " (RESET) button.
Select : Press
End : Press button.
It is possible to finish above setting on the way,
and unfinished change of setting is unavailable.
Note 1: The initial setting marked
Item
Function No.
Remote controller
function02
Remote controller
function06
Remote controller
function07
Remote controller
function13
Remote controller
function15
" (SET) and
button.
is decided by connected indoor and outdoor unit, and is automatically defined as following table.
Default
" , set your desired setting as for the selected item.
Record and keep the
Model
"Auto-RUN" mode selectable indoor unit.
Indoor unit without "Auto-RUN" mode
Indoor unit with two or three step of air flow setting
Indoor unit with only one of air flow setting
Indoor unit with automatically swing louver
Indoor unit without automatically swing louver
Indoor unit with three step of air flow setting
Indoor unit with two step of air flow setting
Indoor unit with only one of air flow setting
Heat pump unit
Exclusive cooling unit
180
- -
setting