Advertisement
4.
Place the 2 halves of the strain relief assembly on either side
of the telephone wire and press together very lightly. Slide the
assembly until it is 2 inches from the terminal posts and press
together firmly.
5.
Insert the strain relief assembly and connected wire into the
slot in the bottom half of the modem case; set it into the recess
in the case. (If the telephone wire does not fit into the strain
relief assembly, call Patton's sales department to obtain a new
assembly).
6.
BEND the top half of the case to place it over the strain relief
assembly. Do not snap the case together yet.
7
7.
Insert one captive screw through a saddle washer and then
insert the entire piece through the hole in the DB-25 end of the
case. Snap that side of the case closed. Repeat on other
side. This completes installation.
3.2.2 Connection Using RJ-11 and RJ-45 Jacks
When using the RJ-11 or RJ-45 modular jacks it is necessary to use
"straight through" cabling between the modems as shown below:
RJ-11 JACKS
SIGNAL
PIN# COLOR
†
DATA
3
Green
GND
4
Red
RJ-45 JACKS
SIGNAL
PIN# COLOR
†
DATA
4
Red
GND
5
Green
Standard color codes—yours may be different
†
1 - Blue
2 - Yellow
3 - Green
4 - Red
5 - Black
6 - White
AT &T standard color codes:
8
COLOR
PIN# SIGNAL
Green
3
DATA
Red
4
GND
COLOR
PIN# SIGNAL
Red
4
DATA
Green
5
GND
1 - Blue
2 - Orange
3 - Black
4 - Red
5 - Green
6 - Yellow
7 - Brown
8 - Slate
Advertisement
