Removal Of The Front Panel; Removal Of The Pcb Unit; Removal Of The Water Flow Sensor, Servo And Bypass Servo - Rinnai INFINITY REU-3203W Service Manual

IMPORTANT
For some areas of dismantling you may need to isolate
any or all of the following:
* Isolate gas supply.
* Disconnect electrical supply from wall socket.
* Isolate water supply.
* Drain all water from appliance.

1) Removal of the Front Panel

a. Remove four (4) screws.

2) Removal of the PCB Unit

a. Remove the front panel. (Refer Item 1.)
b. Remove two (2) PCB unit fixing screws and pull
out forward.
Infinity REU-3203W
3) Removal of the Water Flow Sensor, Servo and
Bypass Servo
a. Remove the front panel. (Refer Item 1.)
b. Remove two (2) screws and locking plates located
on the water supply pipe and bypass pipe. Pull
bypass pipe and water supply pipe forward to
clear servo valves. Ensure O-rings are not lost or
damamged.
* Removal of the Bypass Servo
c. Remove two (2) screws from the water flow servo
body, and pull the bypass servo out forwards.
Ensure O-rings are not lost or damamged..
- 44 - ©Rinnai