Setting The Universal Time Code (Utc) - HP f505g Quick Start Manual

2.4 Powering the Camcorder On / Off
2.4.1 Auto Power On/Off
Once the vehicle engine is started, the camcorder automatically turns
on. If the Automatic Record function is enabled, the recording will
automatically start right away after the camcorder turns on.
Once the vehicle engine is shut down, the camcorder automatically
saves the recording and turns off the power within 10 seconds.
Note:
Automatic power up and shut down assumes the power socket is linked to the car
ignition.

2.5 Setting the Universal Time Code (UTC)

Depending on your location, you may need to change the current UTC
setting of the camcorder so that the correct date and time are
updated when a GPS signal is detected.
1. If recording is in progress, press the
recording.
2. Press the
3. Use the
Synchronization option and press the OK button. Ensure that
the On setting is selected and press the OK button again to view
the UTC setting.
4. Refer to the UTC Map below and use the
select the desired setting and press the OK button to confirm
the setting.
5. Press the
button to open the OSD menu.
or buttons to navigate to the Satellite
button to exit the menu.
button to stop
7
or button to