Hilti DX 36 Operating Instructions Manual page 36

Fault
The cartridge strip doesn't
advance.
The cartridge strip cannot be
removed.
A cartridge doesn't fire.
The cartridge strip melts.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069831 / 000 / 00
Possible cause
The cartridge strip is damaged.
The tool needs to be cleaned.
The tool is damaged.
The tool has overheated.
Bad cartridge.
The tool needs to be cleaned.
The tool is pressed against the
working surface for too long be-
fore firing.
The fastener driving rate is too
high.
Remedy
Change the cartridge strip.
Clean the tool.
If the problem persists: contact
Hilti
Allow the tool to cool down.
Subsequently, carefully remove the
cartridge strip from the tool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip
or tool.
Contact Hilti.
Pull the cartridge strip through to
the next cartridge.
Service the tool (see 9.3)
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip
or tool.
If the tool cannot be disassembled
please contact Hilti.
Fire the tool sooner after pressing it
against the working surface.
Remove the cartridge strip.
Stop using the tool immediately.
Remove the cartridge strip and
allow the tool to cool.
WARNING
Do not attempt to forcibly remove
cartridges from the magazine strip
or tool.
Clean the tool and remove any
loose cartridges.
If the tool cannot be disassembled
please contact Hilti.
en
31