Oven Accessories - Electrolux EKE56403X Operating And Installation Instructions

4. USE OF YOUR PRODUCT
Oven Cavity
Rack positions for molded racks

Oven Accessories

Wire grid
Deep Tray
Rotisserie
Spit handle Spit hole on back
panel of oven
Rotisserie bearing
Tray
bracket or rotisserie
bearing grid
shelf. Before locating the point tip of spit into hole at back panel of oven, turn the small metalic
cover and see the hole. Place the point tip of spit into hole at back panel of oven and the bearing tip
of spit on the rotisserie bearing bracket or rotisserie bearing grid firmly. Also, be sure that the point
tip of spit is placed into hole firmly. During rotisserie, spit handle must never be mounted to spit
and oven door must be in closed position.
5. Rack
4. Rack
3. Rack
2. Rack
1. Rack
Wire grid is used to grill or to place different cookwares on it.
WARNING- Fit the grid correctly
into any corresponding
oven cavity and push it to the end.
Deep tray is used to cook stews.
To locate the tray correctly in the cavity, put it to any rack and
push it up to the end.
Pull out the clamps on spit by loosening their screws and
stick the spit into chicken. Then, mount the clamps by
sliding them on the spit and stick the clamps into chicken.
Tighten their screws. Before doing any operation
described below, be sure that oven and rotisserie function
is not in operation. Put the tray on second shelf and locate
Small metalic
cover
the rotisserie bearing bracket for spit in the holes on the
tray as shown in figure. Some products may have rotisserie
bearing grid accessory instead of the rotisserie bearing
bracket for spit and tray can be placed on first shelf. In this
case, you only need to place the bearing grid on third
Spit
rack in the
17