Mitsubishi Electric AG-150A Instruction Book page 40

5-6-3 Registering general equipment in the group
(1) To register general equipment, touch the unit selection button of the group to set. Select [General equipment (via PAC-YG66DCA)]
on the window that appears to bring up the general equipment registration window. Next, touch the unit number of the general
interface (PAC-YG66DCA) that is connected to the general equipment to be registered. (A yellow green frame will appear around the
selected items.) Select the contact number to which the general equipment is connected, and touch the number assigned to another
unit to register the first selected item to the group (The yellow green frame will change to an orange frame.) The item with a yellow
green frame is the currently selected unit, and the ones with an orange frame are the units that are already registered to a group. To
cancel the connection, select the unit number and touch the selected contact number to deselect it (no orange frame). Press the [OK]
button to save the changes, or touch the [Cancel] button to go back to the previous screen without saving any changes.
Note: A maximum of 16 general equipment can be registered in one group.
Note: To change the registered units to general equipment in the group in which air-conditioners are registered, disconnect the air-
conditioners first.
General equipment
operation setting
button
General equipment
display setting
button
(2) To change the icons, touch the icon selection button, and select the desired icon from the ones that appear.
(3) In the [Allow Operation] section, select whether to enable or disable the ON/OFF operation on the Web browser or on the TG-2000A
operation screen. Select [In batch and on individual group] to enable only when the collective operation is performed. Select [On
individual group] to enable in each group. Select [No operation (Monitor only)] to disable.
General equipment
operation setting
button
(4) In the [Monitor] section, select whether to display I/P to or from the general equipment on the monitor screen.
General equipment
display setting
button
(5) Press the [Save setting] on the group setting window to save the settings.
– 38 –
Unit selection
button
Contact point
selection button