Midea MTA-76C(H)RN1 Technical Manual page 131

MCAC-UTSM-201501
3) Supplied assemblies on the site
Name
4-core shielded cable
86 Electrician box
Wiring tube (Insulating sleeve
and tightening screw.)
4) Installation procedure

The installation manual contains information about the procedure of installing wired
controller. Please refer to indoor unit installation manual for connecting between wired
controller and indoor unit.

Circuit of wired controller is low voltage circuit. Never connect it with a standard 220V or
380V circuit or put it into a same wiring tube with the circuit.

The shield cable must be connected stable to the ground, or transmission may fail.

Don not attempt to extend the shield cable by cutting, if it is necessary, use terminal
connection block to connect.

After finishing connection, do not use mugger to have the insulation check to the signal wire.

Wired remote controller structure size figure ( Unit: mm):
Midea R410A T3 Top-discharge Split Type Series 50Hz
Qty (Embedded Specification (Only
into wall)
1
1
1
Rear view
for reference)
2
0.5mm ×4 The longest is 15m.
\
\
Remarks
\
\
130