Reservoir Tank - Subaru 2004 IMPREZA Service Manual

10.Reservoir Tank

A: REMOVAL
1) Remove the air intake duct. <Ref. to IN(H4SO)-
6, REMOVAL, Air Intake Duct.>
2) Drain fluid from the reservoir tank.
3) Disconnect the pipe D from return hose and suc-
tion hose from oil pump.
CAUTION:
• Do not allow fluid from the hose end to come
into contact with pulley belt.
• To prevent foreign matter from entering the
hose and pipe, cover the open ends of them
with a clean cloth.
(1) Suction hose
(2) Pipe D
(3) Return hose
4) Remove the reservoir tank from bracket by pull-
ing it upwards.
B: INSTALLATION
1) Install the reservoir tank to bracket.
2) Connect the pipes D to return hose and suction
hose to oil pump.
(1) Suction hose
(2) Pipe D
(3) Return hose
3) Feed the power steering fluid to the specified
level. <Ref. to PS-86, Power Steering Fluid.>
Reservoir Tank
POWER ASSISTED SYSTEM (POWER STEERING)
C: INSPECTION
Check the reservoir tank for cracks, breakage, or
damage. If any cracks, breakage, or damage is
found, replace the reservoir tank.
(1)
(2)
(3)
PS-00182
(1)
(2)
(3)
PS-00182
PS-85