Subaru 2004 IMPREZA Service Manual page 31

3) Temporarily connect the pipe C and D to gear
box.
(1) Return hose
(2) Pressure hose
(3) Approx. 30 mm (1.18 in)
(4) Clamp E
4) Temporarily install the clamp E on pipes C and
D.
NOTE:
Ensure the letter "8" on each clamp are opposite
each other as shown in the figure.
(1)
(1) Clamp E
(2) Pipe C
5) Tighten the clamp E firmly.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
Pipe Assembly [RHD MODEL]
PS-00119
(2)
PS-00563
PS-75
POWER ASSISTED SYSTEM (POWER STEERING)
6) Tighten the joint nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
7) Connect the pipes A and B to four pipe joints of
gearbox. Connect the upper pipe B first, and lower
pipe A second.
Tightening torque:
24 N·m (2.4 kgf-m, 17.4 ft-lb)
(1) Pipe A
(2) Pipe B
8) Install the jack-up plate.
9) Install the air intake duct, air cleaner upper cover
and air intake boot.
<Ref. to IN(H4DOTC)-7, INSTALLATION, Air
Cleaner.> and <Ref. to IN(H4SO)-6, REMOVAL,
Air Intake Duct.>
10) Connect the battery ground cable to battery.
11) Feed the specified fluid.
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
PS-00045