Subaru 2004 IMPREZA Service Manual page 23

3) Temporarily connect the pipe C and D to gear
box.
(3)
(6)
(7)
(1) Return hose
(2) Pressure hose
(3) Approx. 30 mm (1.18 in)
(4) Clamp E
(5) Pipe C
(6) Pipe D
(7) Pipe (Gear box side)
4) Temporarily install the clamp E on pipes C and
D.
NOTE:
Ensure the letter "8" on each clamp are diagonally
opposite each other as shown in the figure.
(1)
(1) Clamp E
(2) Pipe C
Pipe Assembly [LHD MODEL]
(1)
(2)
(4)
(5)
PS-00178
(2)
PS-00196
POWER ASSISTED SYSTEM (POWER STEERING)
5) Tighten the clamp E firmly.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
6) Tighten the joint nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
7) Connect the pipes A and B to four pipe joints of
gearbox. Connect the upper pipe B first, and lower
pipe A second.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(1) Pipe A
(2) Pipe B
8) Install the jack-up plate.
9) Install the air intake duct. <Ref. to IN(H4SO)-6,
INSTALLATION, Air Intake Duct.>
10) Install the air intake duct, air cleaner upper cov-
er and air intake boot.
<Ref. to IN(H4DOTC)-7, INSTALLATION, Air
Cleaner.> and <Ref. to IN(H4SO)-6, INSTALLA-
TION, Air Intake Duct.>
11) Connect the battery ground cable to battery.
12) Feed the specified fluid.
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
PS-67
(2)
(1)
PS-00026