Table of Contents
Advertisement
7. Verify the connection. Turn your power source ON. The PWR (power) LED on
your SMD2000-24T faceplate will illuminate solid green to indicate that the chassis
is receiving power.
Connecting the SHDSL RJ21 Cable
Procedure
To connect the SHDSL cable to the SMD2000-24T RJ21 connector:
1. Configure the SHDSL lines.
No configuration is necessary for the SMD2000-24T to operate at default settings.
However, if you wish to run subscriber lines at settings other than the
SMD2000-24T defaults, configure the subscriber lines prior to connection.
Parameter settings may be changed using the Command Line Interface (CLI),
Simple Network Management Protocol (SNMP), or the web-based management
system.
SHDSL Parameter Defaults
Documentation Online
2. Detach the hook-and-loop fastener strap from the RJ21 socket on the front of the
chassis and pull it upward, leaving it looped under the connector frame at the top.
on page 15 lists the device defaults.
on page 3 lists the user interface manuals.
11
Product
Advertisement
Table of Contents
