Table of Contents
Advertisement
•
Install the projector onto a GS1 battery (see
and a power outlet (see
When supplying power directly to the projector please use the supplied power cable to avoid possible dangers such as electric shock and fire.
When the projector is installed onto the GS1 Battery and the supplied power adapter is plugged into the projector the adapter will charge the GS1 battery.
When the projector is installed onto the GS1 Battery and a Micro USB adapter is plugged into the GS1 battery the following situations will occur:
• The adapter will charge the GS1 battery when the projector is powered off.
• The adapter will not provide power to both the battery or projector when the projector is powered on (i.e. projector will only run on battery power when the
projector is powered on).
2. Turn on the power outlet switch (where fitted). The PWR indicator light on the projector lights orange after power has been applied.
3. Connect any video equipment to the respective port on the rear of the projector. If you do not want to project video via such equipment but
want to access the BenQ Launcher, you do not need to connect any video equipment.
For more details on connection options, see
4. Press
on the projector or the remote control to start the projector. As soon as the lamp lights up, the PWR indicator light flashes green and
I
I
stays green when the projector is on.
The fans starts operating, and a start-up image displays on the screen while it warms up, this process may take a few minutes. The projector does
not respond to further commands while it is warming up.
5. If this is the first time you turn on the projector, the setup wizard appears to guide you through setting up the projector. If you have already done
this, skip this step and move on to step 6.
Installing the battery on page
Connections on page
69).
Connection on page
29.
68) and then plug the supplied power adapter into the projector
35
Advertisement
Table of Contents
