Ignition Timing; Thunderbolt V Models - MerCruiser 305 CID (5.0L) Service Manual

SERVICE MANUAL NUMBER 24
7. While holding adjustment stud at the correct belt tension, tighten 5/8 in. locking nut.
8. Run engine for a short period of time and recheck belt adjustment.

Ignition Timing

Thunderbolt V Models

1. Connect timing light to number 1 spark plug wire.
2. Connect a shop tachometer to the engine.
IMPORTANT: Before starting the engine, connect a jumper wire from the igniton tim-
ing lead to a good ground. This has to be done before the ignition key is turned ON
to lock the igniton module into Base Timing Mode.
3. Before starting the engine, connect jumper wire from timing lead to a good ground.
NOTE: The PUR/WHT timing lead is located towards the front of the engine near the fuel
line or near the distributor, as equipped for your model.
4. Start engine and run at 1300 rpm until it reaches normal operating temperature.
5. Disconnect throttle cable from the carburetor.
6. With engine at idle rpm, adjust the caeburetor idle rpm screw to the specified engine idle
rpm.
7. With the engine still at idle rpm, check the ignition timing. If incorrect, rotate the
distributor until timing is correct. Torque clamping screw to 18 lb-ft (25 Nm).
8. Adjust the idle mixture screw. Inward is LEAN, outward is RICH.
9. Recheck ignition timing.
10. Stop engine. Remove timing light, jumper wire and shop tachometer.
IMPORTANT: Timing jumper wire has to be removed or the ignition module will stay
locked in the Base Timing Mode and it will not be able to advance the ignition timing
correctly when the engine rpm is increased.
11. Adjust and reinstall throttle cable. Open and close remote control throttle lever to make
sure that the carburetor's throttle lever returns against the rpm adjusting screw every
time.
Index
90-861327--1 OCTOBER 1999
a - 5/8 in. Locking Nut
b - 5/16 in Adjusting Stud
a
b
MAINTENANCE
7490
Page 1B-37