FUEL INJECTION DISASSEMBLY AND REASSSEMBLY
Fuel Pressure Relief Procedure
Refer to "Service Precautions," at front of this section BEFORE proceeding.
1. Disconnect electrical connector at fuel pump.
2. Crank engine for ten seconds (if engine starts allow it run until it stops) to relieve any
fuel pressure in the system.
350 Mag MPI Components
Flame Arrestor
Refer to "Service Precautions," at front of this section BEFORE proceeding.
REMOVAL
1. Remove the flame arrestor cover.
Typical Connections
Index
Page 5E-8
b
c
a -
Flame Arrestor Cover
b -
Nut
c -
Washer
NOTICE
NOTICE
a
a
75831
SERVICE MANUAL NUMBER 24
76365
90-861327--1 OCTOBER 1999