MerCruiser 305 CID (5.0L) Service Manual page 338

SERVICE MANUAL NUMBER 24
2. Install front bearing retaining plate using three Phillips head screws and lockwashers.
3. Slide front end frame over rotor.
4. Assemble stator to rectifier by soldering the three leads to the three rectifier terminals.
NOTE: Be sure to connect leads to their original positions.
5. Install assembled stator and rectifier assembly into rear end frame, aligning scribe
marks on each (scribed during disassembly), and install Phillips head screw and washer
to retain.
IMPORTANT: The insulating washers MUST BE installed as shown or damage to the
alternator will result.
6. Position stator down with rear end frame up and reinstall insulators, nuts and condenser.
Index
90-861327--1 OCTOBER 1999
a - Phillips Head Screws And Lockwashers
b - Front Bearing Retaining Plate
a - Stator Lead Connections
a - Insulators (3)
b - Nuts (5) One Removed
c - Condenser
a
a
b
a
CHARGING SYSTEM
b
c
b
Page 4C-23
72829
72826
72561