MerCruiser 305 CID (5.0L) Service Manual page 145

SERVICE MANUAL NUMBER 24
Hurth Transmissions
On the Hurth 8° Down-Angle and V-Drive Transmissions the transmission identification
plate indicates gear ratio, serial number and model.
Typical Hurth Down-Angle Transmission Shown (V-Drive Identification Plate
Similarly Located)
On Velvet Drive In-Line and V-Drive Transmissions the gear ratio (in forward gear) is marked
on transmission identification plate. Transmission output shaft rotation and propeller rota-
tion required (in forward gear) is indicated on a decal on transmission case. Transmission
rotation is described when viewed from the rear of transmission.
Torque Specifications
Battery Cables
Engine Mount Pads
Hose Clamps
Mount Locking Nut
Propeller Shaft Coupler To Transmission Output Flange
Trunnion Clamping Screw / Nut
Remote Control Shift Cable
Remote Control Throttle Cable
NOTE:
NOTE:
Index
90-861327--1 OCTOBER 1999
a - Transmission Identification Plate
Fastener Location
1
Tighten, then loosen nut 1/2 turn.
2
Bend tab against adjusting nut.
a
73587
lb-in.
Cable Barrel
Cable End Guide
Cable Barrel
Cable End Guide
MIE MODELS
lb-ft Nm
Securely
Securely
NOTE 2
50 68
Securely
NOTE 1
Securely
NOTE 1
Page 2B-3