Remote Wiring Harness - Mercury optimax 115 Installation Manual

Remote Wiring Harness

1. Connect wiring. Push the retainer over the ends of the connectors. This will hold the con-
nectors together. Place the harness connection and retainer into the cable holder lo-
cated in the bottom cowl has shown.
d
a - Power Trim Connections
b - Wire Connection For Analog Water Temp Gauge – Not Supported by this En-
gine
c - Connection For Non SmartCraft Analog Trim Gauge
d - Retainer – Push Over Connector Ends
e - Cable Holder
BLU/WHT
BLU/WHT
GRN/WHT GRN/WHT
TAN
TAN
BRN/WHT
BRN/WHT
75/90/115 OPTIMAX
e
a
b
c
Page 9 of 18