Ap4.6 Setting Active Port - Nera Inmarsat-c Service Manual

AP4.6 Setting Active Port

Set "Active Port " and "Message Output Port" in "System Setup" menu to "ALL" and
"INT" respectively. (Keystroke: [F8][2]) The received message is saved in Nera C
and then transferred to PC.
Procedure
1. Press [F8][2] to show "System Setup" menu.
2. Select "Active Port".
3. Select "ALL", followed by [Enter].
4. Select "Message Output Port".
5. Select "INT", followed by [Enter].
6. Press [Esc]. The "Update" window appears.
7. Select "Yes", followed by [Enter] to update the setting.
8. Press [Esc].
INT
Active Port
ALL
INT
EXT
Message
Output
INT+EXT
Port
AUTO
Table AP4.6.1 Active Port" and "Message Output Port
DTE and LAN ports are inactive.
DTE and LAN ports are active.
Received message is saved in the memory on Nera C.
Received message is output from DTE and LAN ports.
Received message is saved in Nera C memory and output
from DTE and LAN ports at a time.
Received message is output according to Sub Address setting.
(Internal memory and LAN: 000; DTE: 001)
AP4-7
AP4.6 Setting Active Port