Sanyo DC-F450 Instruction Manual page 13

f
RECORDING FROM THE TUNER OR VIDEO 6. Press the button to stop recording.
INPUT
When beat interference is heard
1.
2,
3.
4.
5.
Load a blank cassette into deck B.
A high-pitched noise called "beat" is sometimes heard during the recording
Tune in the radio station to be recorded, or play a video cassette or
of radio broadcasts.
If this occurs,
video disc.
Press the REC PAUSE button. Deck B enters the record pause mode.
1. Press the MEMORY button.
Press the button. Recording starts.
2, While "PROG." is blinking, press the >/ N SKIP/SEARCH button
Press the REC PAUSE button to temporarily stop recording, Press the
to select "be-l" or "be-2". Select the setting that gives the best results.
E button again to continue,
TAPE DUBBING (Deck A to Deck B)
Load the cassette to be played back into deck A and a blank cassette into
deck B.
High-speed dubbing
For simple, automatic dubbing in one-half the time, compared to normal-
speed dubbing.
1,
2.
3.
Use the same length cassettes in both decks for the high-speed
dubbing operation.
Press the DUBBING HIGH button. "TAPE" is selected automatically
and '(dub appears on the display.
The system performs the steps below and automatically starts deck
A playback and deck B recording.
1) Deck A: Tape rewinds,
2) Deck B: Tape rewinds,
3) Deck B: Erases the first few seconds of the tape.
The REC PAUSE, DECK B and DECK A indicators light, "dub and
"W' appear on the display as dubbing begins.
dub
-
3
When side A of deckA has been dubbed, both decks stop automatically.
Turn over both cassettes and reinsert them,
Press the DUBBING HIGH button to dub side B of deck A.
Before pressing the DUBBING HIGH button, check that both decks
are in the stop mode,
Press the button to stop dubbing at any time. The tape will not stop
during high-speed dubbing if the REC PAUSE button is pressed.
During high-speed dubbing, normal monitoring is not possible.
High-speed dubbing must start from the beginning of the tape. To start
dubbing from a position in the middle of the tape, use manual dubbing.
Manual (normal-speed) dubbing
For dubbing while listening to the playback from deck A.
1,
2,
3.
4,
5.
6.
Select "TAPE.
Deck B: Locate the tape position where recording will begin.
Deck A: In the forward direction, locate the selection of the tape to be
dubbed.
Press the REC PAUSE button. The REC PAUSE and DECK B
indicators light. " " blinks on the display,
Press the button. The DECK A indicator and " " light. Manual
dubbing starts.
Deck A playback will start in the forward direction.
Press the button to stop dubbing.
Automatic stop during tape dubbing
If deck A or deck B stops automatically, the other deck will also stop.
During tape dubbing, the DOLBY NR button has no effect on the
copied tape. If the tape to be copied is encoded with Dolby NR, the
copy will be Dolby NR encoded automatically.
12