Catler 400 series Instruction Manual page 21

TO USE THE WHISK
For food preparation tips and recipes refer
to the recipes section. Ensure the whisk
is completely and properly assembled.
1. Place food to be processed into
a blending jug or a suffi ciently large
mixing bowl or container.
2. Insert the plug into a 230/240V power
outlet and turn the power on.
3. Select a speed between 1–15 on the
speed control dial.
4. Place the whisk into food and press the
trigger switch to turn the whisk on.
5. Move the whisk through the ingredients
with a gentle raising and lowering action
until desired texture is achieved.
6. Switch off the motor by releasing the
trigger switch before lifting the whisk
out of the bowl. Switch off at the power
outlet and remove the power plug.
TO DETACH THE WHISK
Ensure the trigger switch is released, the
power is turned off at power point and the
appliance is unplugged. Hold the motor
body with one hand, and using thumb and
fi nger of the other hand, press on the two
EJECT buttons on either side of the motor
body. Pull the motor body away from the
whisk to detach.
RECOMMENDATIONS WHEN USING THE
WHISK ATTACHMENT
• Do not allow the whisk to hit the bottom
or sides of mixing bowl while the
appliance is in operation, as this may
damage the whisk.
• To incorporate air into the ingredients
when whisking, use a suffi ciently deep,
wide container and move the whisk
through the ingredients with a gentle
raising and lowering action.
• Release the trigger switch and ensure the
whisk has completely stopped turning
before removing the whisk from the food
during operation.
• Place the mixing bowl on a damp cloth
during whisking. This will keep the
mixing bowl stable.
• Always use fresh chilled cream and fresh
eggs at room temperature to achieve
greater and more stable volume when
whisking.
• Always ensure the whisk and mixing
bowl are completely clean and free of fat
before whisking egg whites.
• It is recommended to use the highest
speed when whisking egg whites and
cream.
STORAGE
Before storage, turn the power off at the
power outlet and then remove the plug.
Ensure the appliance is clean and
completely dry.
Attach/assemble chopper bowl lid to the
chopper bowl, place chopper bowl inside
blending jug, attach storage lid to the
bottom of the blending jug (non-slip base).
21
ASSEMBLY & OPERATION