Application - D-Link DSL-3782 User Manual

Section 4 - Configuration
Port triggering allows ports to be opened when traffic is detected on specified
ports. This is used for facilitating communication between applications and
servers behind a NAT firewall. To access this page, click Application from the
Features menu on the bar on the top of the page.
The currently defined Application rules are displayed in the table. Some
commonly used Applications are pre-configured by default. You may create
up to eight application rules. If you wish to remove an application rule, click
on its trash can icon in the Delete column. If you wish to edit an application
rule, click on its pencil icon in the Edit column. If you wish to create a new
application rule, click the Add Rule button.
Create New Rule
Enable Enable or disable the Application rule.

Application:

Name:
Enter a name for this application.
Trigger Port Start:
Enter the starting port range traffic will be forwarded from.
Trigger Port End:
Enter the ending port range traffic will be forwarded from.
Trigger Traffic Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Protocol Type:
Open Port: Enter the port or port range to open once triggered.
Select the protocol to trigger this rule: TCP, UDP, or All Protocol.
Open Traffic
Protocol Type:
Click Apply when you are done.
D-Link DSL-3782 User Manual
Application
49