Table of Contents
Advertisement
Section 4 - Configuration
If you enabled IP filtering, click Add Rule to create a new IP filtering rule.
Create New Rule
Name:
Create a name for the rule.
Select the protocol type: Any, UDP, TCP, or ICMP.
Protocol:
Select Any IP address, Single IP, or Specify IP Address (Range). If
Source IP Address:
you selected Single IP or Specify IP Address (Range), enter the IP
address into the From and To fields.
Destination IP
Select the destination to apply the rule to: PVC1, PTM, or WAN.
Address:
Select Any IP address, Single IP, or Specify IP Address (Range). If
you selected Single IP or Specify IP Address (Range), enter the IP
address into the From and To fields.
If you selected PTM or WAN as the Destination IP Address, select the Service Number.
Service Number:
Select the Service Number from the drop down menu.
If you selected UDP or TCP as the Protocol above, you may filter Any Port, a Single Port,
or Specify a Port Range.
Schedule:
Use the drop-down menu to select the time schedule that the rule will
be enabled on. The schedule may be set to Always, or you can create
your own schedules in the Schedules section. Refer to Schedule on
page 62 for more information.
Click Apply when you are done.
D-Link DSL-3782 User Manual
IP Filter (continued)
55
Hide quick links:
Advertisement
Table of Contents
