Recommended Components For Connection - Fujitsu MCE3064SS Product Manual

Table 3.4
Category
SCSI cable Cable socket
(closed-end type)
Cable socket
(through-end type)
Signal cable
Power supply cable Housing for cable
socket
Contact
Cable
External operator panel Housing for cable
socket
Receptacle
Cable
(1) SCSI cable
All SCSI devices on one bus are daisy-chained with an SCSI cable. A terminating resistor must
be mounted in the SCSI device at each end of the SCSI cable.
A terminating resistor is mounted on the drive when the drive is shipped. A terminating resistor
must be disconnected when the drive is not connected to an end of the SCSI cable. Select a
method of power supply to the terminating resistor circuit according to the setting pins on the
drive. See Section 4.3 for details.
Up to eight SCSI devices can be connected to the SCSI bus. SCSI devices include the host
adapter, the optical disk drive, and other SCSI equipment.
The connector (socket) for the SCSI cable must be an unshielded 50-contact socket with two
rows of 25 contacts on 2.54 mm (0.1 inch) centers. The connector should also be polarized or
keyed to prevent misinsertion. (See Figure 3.17.)
3 - 18

Recommended components for connection

Name Model
FCN-707B050-AU/B
FCN-707B050-AU/O
UL20184-
LT25PX28AWG
455-248-50
1-480424-0
170121-4
AWG18
LPC-16F02
LPC-F104N
AWG28
C156-E097-01EN
Manufacturer Symbol in Figure
3.19
Fujitsu Ltd. S01
Fujitsu Ltd.
Hitachi Cable, Ltd. —
SPECTRA-STRIP
AMP S2
AMP
— —
Honda-Tsushin SH2
Honda-Tsushin
— —