(1)
Power supply connector
Figure 3.14 shows the shape and pin assignment of the DC power supply input connector.
(2)
SCSI connector
The connector for the SCSI bus is an unshielded standard connector with two rows of 25 pins
on 2.54 mm (0.1 inch) centers. Figure 3.15 shows the SCSI interface connector. Table 3.3
shows the signal assignment of the SCSI bus connector.
See Chapter 7 for details on the electrical requirements of the interface signals.
Symbol
Note:
Tolerance is ±0.127 mm (0.005 inch) unless otherwise specified.
Figure 3.14 Power supply connector
mm
Inch
Figure 3.15 SCSI interface connector (drive side)
C156-E097-01EN
1 +12 VDC or N.C.
2 +12 VDC RETURN (GND) or N.C.
3 +5 VDC RETURN (GND)
4 +5 VDC
Remark
3 - 15