Advertisement
STEP 9
Assemble the PUSH/PULL CABLE from the PRESS ARM (8) to the SPRING PIN HOUSING and to the L-BRACKET on the
RECEIVING TUBE (13) as shown on FIGURE 9 and DETAIL 9 using the following steps:
· Thread the first 1/4-28 IN. NUT to the bottom of the threaded end of the CABLE. Allow the other 1/4-28 IN. NUT to hang loose
on the exposed CABLE until the SPRING PIN ASSEMBLY is attached.
·
Securely assemble the SPRING PIN ASSEMBLY to the
SPRING PIN BARREL. (!!! IMPORTANT !!! TIGHTEN
THE NUT OF THE SPRING PIN ASSEMBLY SE-
CURELY)
· Swing the PRESS ARM (8) up until the SPRING PIN of the
PUSH/PULL CABLE engages in one of the adjustment
holes.
· Thread the second 1/4-28 IN. NUT onto the threaded end of
the CABLE, and cinch the two 1/4-28 IN. NUTS around the
flat.
· Use the extra thread on the end of the CABLE to adjust out
slack. ( !!! DO NOT ADJUST OUT TO FAR !!! AL-
WAYS ALLOW SPRING PIN ASSEMBLY TO FULLY
ENGAGE)
STEP 10
•
Securely tighten two 5/32" SET SCREWS (65) and insert
two 3 X 2" END CAPS (75) into the open ends of PRESS
ARM (8) as shown in FIGURE 10.
•
Securely tighten two 5/32" SET SCREWS (65) and insert
two 2" SQ. END CAPS (76) into the open ends of PRESS
ARM LEVER (9) as shown in FIGURE 10.
• Securely tighten one 3/8 X 1" BOLT (35), one 3/8" WASHER
(51), and one 3/8" LOCKNUT (48) to the bottom of AD-
JUSTMENT SLIDE (6) as shown in FIGURE 10.
•
Insert one 1-3/4" SQ. END CAP (77) into the end of AD-
JUSTMENT SLIDE (6) as shown in FIGURE 10.
1/2
0
DETAIL 9
8
13
FIGURE 9
1/2
1/2
1
2
PUSH/PULL
CABLE
1/4" NUTS
DO NOT OVERTIGHTEN!
SPRING PIN
ASSEMBLY
75
76
51
3/8 X 1" 35
FIGURE 10
1/2
3
4
9
8
65
9
65
48
77
1/2
1/2
5
13
DETAIL 9
6
6
Advertisement
