Advertisement
FIGURE 24
STEP 24
• Securely attach BACK SEAT PAD (26) to BACK PAD SUPPORT (14) using two 3/8 X 2-3/4" (38) and two 3/8" WASHERS (51).
• Securely attach LEG SEAT PAD (28) to HINGE TABS (78) using two 3/8 X 1" (35) and two 3/8" WASHERS (51) as shown in
FIGURE 24.
STEP 25
Assemble the LEG CURL/EXTENSION (4) to the BENCH FRAME (15) using the following steps:
15
45 1/2 X 4-1/2"
FIGURE 25
51
3/8 X 2-3/4" 38
35 3/8 X 1"
90
51
48
26
14
50
1/2" LOW
HEIGHT
67
4
18
28
78
51
35 3/8 X 1"
• Insert two 1/2" FLANGE BEARINGS (67)
into the LEG CURL/EXTENSION (4).
• Assemble the LEG CURL/EXTENSION (4)
to the BENCH FRAME (15) using one 1/2
X 4-1/2" (45) and one 1/2" LOW HEIGHT
LOCKNUT (50). (NOTE: Securely tighten,
then back nut off 1/4 turn to allow the LEG
CURL/EXTENSION (4) to rotate freely.)
• Securely fasten 227" CABLE (90) to the LEG
CURL/EXTENSION (4) using one 3/8 X 1"
BOLT (35), one 3/8" WASHER (51), and
one 3/8" LOCKNUT (48) as shown in FIG-
URE 25.
Advertisement
