Abus tvac18000c User Manual page 6

7. Wireless transmission
The wireless range depends on a variety of environmental factors. The local conditions at the installation
site may have a negative impact on the range. When there are no obstructions between the receiver and
transmitter, a range of up to 325 feet is possible, but this range will be considerably less within buildings.
The following environmental conditions compromise both the range as well as the frame rate:
Mobile communication masts, high-tension pylons, electrical wires, ceilings and walls, devices with the
same or an adjacent wireless frequency.
Disclaimer
ABUS USA, LLC products are not manufactured and/or sold with the intent to be used for
illegal purposes. ABUS USA, LLC expects consumer's use of these products to be in
compliance with all local, state and federal law. For further information on video surveillance
and audio recording legal requirements, please consult your local, state and federal law. It is
your responsibility to be aware of the local, state and federal regulations regarding image
storage and use.
Warnings
Follow all safety and operating advices before starting-up the device!
1. Follow these directions in order to avoid damage of the power cord or plug:
 Do not modify or process the power cord or plug arbitrarily.
 Make sure to disconnect the power cord holding the plug.
 Keep heating appliances as far as possible from the power cord in order to prevent the vinyl
cover from melting.
 The outdoor camera's power supply unit must be protected against humidity and damp
conditions.
2. Failure to follow these directions may cause electrical shock.
 Do not open the main body or the power supply.
 Do not insert metal or inflammable objects inside the product.
 In order to avoid any damage during lightning use a surge protector.
3. Do not use if it is found to be defective. If you continue to use the product when defective, serious
damage can occur. Make sure to contact your local product distributor if the product is found to be
defective.
During the installation into an existing video surveillance system make sure that all devices are
disconnected from the low supply voltage circuit.
If in doubt allow a professional electrician to mount, install and wire-up your device. Improper
electrical connection to the mains does not only represent at threat to you but also to other persons.
Wire-up the entire system making sure that the mains and low voltage circuit remain separated and
cannot come into contact with each other in normal use or due to any malfunctioning.
Avoid using the device under the following unfavorable conditions:

moisture or excessive air humidity

extreme cold or heat

direct sunlight

dust or combustible gases, vapors or solvents

strong vibration

strong magnetic fields, such as those found in the vicinity of machinery or loudspeakers

the camera must not be directed into the sun as this can destroy the sensor.

the camera may not be installed on unstable surfaces
6
English