If the output interfaces are not the same, execute the reset command to clear the route entries.
Then the switch can learn route entries again.
4.
If the problem persists, contact HP Support.
Related commands
This section lists the commands that you might use for troubleshooting Layer 3 forwarding failure.
Command
debugging arp packet
display arp
display ip routing-table
display mac-address
display fib
Protocol flapping
Symptom
The switch cannot send or receive protocol packets.
Troubleshooting flowchart
Figure 16 Troubleshooting protocol flapping
Description
Enables ARP packet debugging.
Displays ARP entries.
Displays brief information about active routes in the routing
table.
Display MAC address entries
Display FIB entries
45