Related Commands - HP 5920 series Troubleshooting Manual

IMPORTANT:
Activating IRF port configuration requires a reboot. To prevent configuration loss, you must save
the configuration before you execute the irf-port-configuration active command.
7. Verify that all member devices use the same software version:
a. Execute the display version command to identify the software version of each member device.
b. Upgrade the software of all member devices to the same version.
NOTE:
Typically, the irf auto-update enable command can automatically synchronize a member device with
the software version of the master device. However, the synchronization might fail when the gap
between the software versions is too large. For more information, see the release notes.
8. If the problem persists, contact HP Support.

Related commands

This section lists the commands that you might use for troubleshooting IRF.
Command
display interface
display irf
display irf configuration
display irf topology
display version
irf-port-configuration active
undo shutdown
Description
Displays interface information.
Use this command to verify that each IRF port has a minimum of one
physical interface in up state.
Displays IRF fabric information, including the member ID, role, priority,
bridge MAC address, and description of each IRF member.
Displays basic IRF settings, including the current member ID, new
member ID, and physical interfaces bound to the IRF ports on each IRF
member device. The new member IDs take effect at reboot.
Displays the IRF fabric topology, including the member IDs, IRF port state,
and adjacencies of IRF ports.
Displays system version information.
Activates IRF configuration on IRF ports.
Brings up an Ethernet interface or subinterface.
15