Reconnect Battery; Removing The Unit - Jensen JRV215N Installation And Operation Manual

CAUTION: The perforated rear support strap or rear rubber mounting bushing
must be used in the installation of the radio. Installation without either may result
in damage to the radio or the mounting surface and void the manufacturer's
warranty.
9. Test radio operation by referring to the operating instructions for the unit.

Removing the unit

To remove the radio after installation:
Make sure the ignition is turned off, and then disconnect the cable from the vehicle's
1.
battery negative (-) terminal.
2. Insert the removal keys straight into the holes on the front of the unit, as far as they will go.
3. Pull the radio straight out.
Hardware Kit Contents
Key, EGI, T=1.00 (x2)
Mounting Bracket

Reconnect Battery

When wiring is completed, reconnect the battery negative terminal.
8
JRV215N
Thread Bolt Rubber
Machine Screw M5
Serrated Hex Flange Nut, M5