HP 5500 HI Series Installation Manual page 20

Attach the front mounting brackets to the chassis:
2.
Unpack the front mounting brackets and the M4 screws for attaching the brackets to the switch
a.
chassis.
Align the round holes in the wide flange of one front mounting bracket with the screw holes in
b.
the port-side mounting position on one side of the chassis (see
Use M4 screws (supplied with the switch) to attach the mounting bracket to the chassis.
c.
Repeat the proceeding two steps to attach the other mounting bracket to the chassis.
d.
Attach the load-bearing screws to the chassis and the rear mounting brackets to the rack:
3.
Unpack the rear mounting brackets and the load-bearing screws.
a.
Install the load-bearing screws in one of the load bearing screw mounting positions (see
b.
20) as needed.
Figure 20 Attaching the front mounting brackets and load bearing screws to the chassis
Install cage nuts (user-supplied) in the mounting holes in the rear rack posts.
c.
Attach the rear mounting brackets to the rear posts with M6 screws (user supplied), as shown
d.
in Figure 21.
Figure 21 Attaching the rear mounting brackets to a rack
15
Figure 20).
Figure