Paramount Fitness PCC2000 Owner's Manual page 14

Method 2: Small Nozzles
Some PCC2000 systems used the large floor nozzle in the steps. See Method 1 for removal
and installations instructions. PV3, Cyclean and PCC2000 step nozzles see Figure 8. Using
the removal tool common to these nozzles, attach the tool to the end of your pool pole placing it
over the nozzle and making sure the tool tabs insert into the nozzle slots. Turn the tool counter-
clockwise a ¼ turn to unlock the nozzle and then lift it from the body in the floor of the pool. Make
sure the o-ring on the bottom of the nozzle is in place. When replacing the nozzle, lock the nozzle
into the tool on the end of your pool pole and replace the nozzle in the body and turn clockwise to
lock into the body.
Method 3: Pool Valet
Pool Valet (released in 1980) and Step Clean see Figure 9. Using the removal tool common
to these nozzles, place the ends of the U-shaped tool in 2 of the slots and turn counter-
clockwise. This is a threaded retainer ring that will require 3 full turns to remove. If you
experience difficulty unthreading the retainer ring tap on it gently. This is best accomplished
by tapping on the top of the tool. The amount of force necessary can vary depending on
how long the nozzle has been installed. When replacing the threaded ring of the nozzle
wrap it twice with Teflon tape. This will make for easy removal in the future. Turn it clockwise
approximately 3 turns until it is snug in the body.
Method 4: New Generation Pool Valet
New Pool Valet (October 2012) Using the removal tool common to these nozzles, place the
tool in the 4 slots and turn counter-clockwise. This is a threaded retainer ring that will require
1 full turn to remove. If you experience difficulty unthreading the retainer ring tap on it gently.
When replacing the nozzle, snap the center of the nozzle into the tool on the end of your pool
pole and replace the nozzle in the body, turning clockwise 1 full turn to lock into the body.
14
Figure 8
Part Number: 004-627-5452-00
Small nozzle tool part #004-552-5452-00
Figure 9
Part Number: 004-502-5420-00
Pool Valet nozzle tool part #004-502-5420-00
Figure 10
Pool Valet nozzle tool part #004-502-5420-00