Unpacking And Assembly - Makita PTM1000 Operator's Manual

UNPACKING AND ASSEMBLY

3. UNPACKING AND ASSEMBLY
For storage and transport reasons, some components of the machine are not directly
installed in the factory, but have to be assembled after their removal from the packing.
Final assembly is carried out by following these simple instructions.
IMPORTANT
up the engine, fill with oil and fuel following the instructions given in the engine man-
ual.
3.1 UNPACKING
When unpacking the machine, take care to gather all individual parts and fittings, and
do not damage the cutting deck when taking the machine off the base pallet.
The packing contents:
– the machine;
– the battery;
– the steering wheel;
– the seat;
– the grass-catcher brackets;
– the grass-catcher components;
– an envelope containing:
– the operator's manuals and documents,
– the nuts and bolts including a pin for blocking the steering wheel,
– 2 starter keys and a spare 10 A fuse.
NOTE
down from the pallet, take it to the maximum height and be very careful.
hydrostatic drive models: to make it easier to get the machine off the pallet and to
move it, the drive disengage lever should be put in position «B» (
3.2 FITTING THE STEERING WHEEL
Put the machine on a flat surface and straighten up
the front wheels. Fit the steering wheel (1) onto the
protruding shaft (2) so that the spokes are correctly
lined up.
Move the front wheels to turn both the shaft (2) and
the steering wheel (1) about a quarter of a turn in
order to get to the hole (3) on the shaft.
The machine is supplied without engine oil or fuel. Before starting
To prevent damaging the cutting deck when getting the machine
4.33).
1
9
EN
For