Superimpose Screen - Panasonic AU-65H Operating Instructions Manual

Superimpose Screen
When the SUPER switch on the B1.SYSTEM CONTROL board in the unit is set to ON, the superimpose signal is added
to the signal which is output from the VIDEO OUTS3 connector.
eSuperimpose displays are not possible in the set-up menu mode.
Block 1
Block 3 >
Block 1
The time code mode is indicated in this block by the abbreviations listed below.
VTCR: VITC time code playback value
Block 2
The time code is indicated in hours, minutes, seconds and frames (fields) as below.
=odd number field
=even number field
12:34: =<==:()
()
(blank) = Time code cannot be read.
Block 3
This displays the VTR operating modes as below.
E-59