Operation - Craftsman 315.115810 Manual

WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer
of this tool. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this tool for the following purposes:
 Drilling in wood
 Drilling in ceramics, plastics, fiberglass, and laminates
 Drilling in metals
 Mixing paint
This product will accept DieHard
tery packs and Craftsman 19.2 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
BATTERY PROTECTION FEATURES
DieHard 19.2 V lithium-ion battery packs are designed
®
with features that protect the lithium-ion cells and
maximize battery life.
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
TO INSTALL BATTERY PACK
See Figure 2.
 Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
 Place battery pack in the drill. Align raised rib on
battery pack with groove inside drill.
 Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in drill
before beginning operation.
CAUTION:
When placing battery pack in the drill,
be sure raised rib on battery pack aligns with groove
inside drill and latches snap into place properly.
Improper assembly of battery pack can cause damage
to internal components.

OPERATION

19.2 V lithium-ion bat-
®
BATTERY
PACK
DEPRESS LATCHES TO
RELEASE BATTERY PACK
TO REMOVE BATTERY PACK
See Figure 2.
 Lock switch trigger on the drill by placing the direction
of rotation selector in center position.
 Locate latches on side of battery pack and depress to
release battery pack from the drill.
 Remove battery pack from the drill.
9
LATCHES
Fig. 2