Table of Contents
Advertisement
BIT STORAGE
See Figure 8.
When not in use, bits provided with the drill can be placed
in the storage area located on the base of the drill.
SCREWDRIVER BIT
BIT STORAGE AREA
INSTALLING BITS
See Figures 9 - 10.
Lock the switch trigger by placing the direction of
rotation selector in the center position.
Open or close the chuck jaws to a point where the
opening is slightly larger than the bit size you intend to
use. Also, raise the front of the drill slightly to keep the
bit from falling out of the chuck jaws.
Insert the drill bit.
Tighten the chuck jaws on the drill bit.
WARNING:
Do not insert drill bit into chuck jaws
and tighten as shown in figure 11. This could cause
drill bit to be thrown from drill resulting in possible
serious personal injury or damage to the chuck.
Rotate the chuck clockwise to tighten the chuck jaws
securely on the bit.
NOTE: Rotate the chuck body in the direction of the
arrow marked LOCK to tighten the chuck jaws. Do not
use a wrench to tighten or loosen the chuck jaws.
OPERATION
DRILL BIT
CHUCK
JAWS
Fig. 8
REMOVING BITS
See Figure 9.
Lock the switch trigger by placing the direction of
rotation selector in the center position.
Rotate the chuck sleeve clockwise to open the chuck
jaws.
NOTE: Rotate the chuck body in the direction of the
arrow marked UNLOCK to loosen the chuck jaws. Do
not use a wrench to tighten or loosen the chuck jaws.
Remove the drill bit.
12
UNLOCK
(RELEASE)
LOCK
CHUCK
(TIGHTEN)
BODY
RIGHT
WRONG
CHUCK
COLLAR
Fig. 9
Fig. 10
Advertisement
Table of Contents
