Interface - Panasonic AJSD930P Operating Instructions Manual

Setup menus
USER menu
<INTERFACE>
No./Item
200 This selects whether two or more VTRs are to
be operated in synchronization.
PARA RUN
0000 DIS : No operation in synchronization
0001 ENA : Operation in synchronization
<Note>
When operating
synchronization, set all the VTRs to ENA.
201 This selects whether the REMOTE (9P)
connector functions when the CONTROL
9P SEL switch has been set to REMOTE.
0000 OFF : Connector does not function.
0001 ON : Connector functions.
202 This sets the ID information to be returned to
the controller.
ID SEL
0000 OTHER
0001 DVCPRO
0002 ORIG
<Notes>
OID information of any VTR except for the
DVCPRO's is set in OTHER.
OThe ORIG setting should only be used when a
Panasonic controller (AG-A850 etc. sold
separately) is connected.
203 This selects whether the PARALLEL (25P)
connector functions when the CONTROL
25P SEL switch has been set to REMOTE.
0000 OFF : Connector does not function.
0001 ON : Connector functions.
204 This selects whether the RS-232C connector
functions when the CONTROL switch has
RS232C SEL been set to REMOTE.
0000 OFF : Connector does not function.
0001 ON : Connector functions.
205 These settings are for selecting the RS-232C
communication speed (baud rate).
BAUD RATE
0000 300
0001 600
0002 1200
0003 2400
0004 4800
0005 9600
206 These settings are for selecting the RS-232C
data length. (Unit: bit)
DATA
LENGTH 0000
0001
207 These settings are for selecting the RS-232C
stop bit length. (Unit: bit)
STOP BIT
0000
0001
The underlined items indicates the initial setting.
Description
two or more VTRs
7
8
1
2
No./Item
208 These settings are for selecting the none, odd
or even for the RS-232C parity bit.
PARITY
0000
Parity bit is not used.
0001
in An odd number of bits is used for the parity
system.
0002
An even number of bits is used for the parity
system.
209 These settings are for selecting whether the
ACK code is to be returned when a command
RETURN ACK is received from RS-232C.
0000
0001
210 For selecting the method used to detect the
STANDBY COMMAND signal input at the
25P STBY PARALLEL (25P) connector.
CMD
0000 OFF/ON :
Each time active signals are detected, the
STANDBY ON or STANDBY OFF mode is
selected alternately.
0001
When active signals are detected in the
STANDBY OFF mode, the unit is transferred to
the STANDBY ON mode.
Nothing happens if they are detected during an
operation in the STANDBY ON mode.
211 This selects whether the PARALLEL (25P)
connector is to function when the CONTROL
LOCAL 25P switch is at the LOCAL position.
0000
0001
212 SD955A For selecting the remote control connector to
control the slave when the unit is used as the
MASTER master during deck-to-deck operations.
PORT
0000 IN/OUT : The IN/OUT connector is used.
0001
<Note>
This menu item takes effect only when the
CONTROL switch has been set to the LOCAL
position.
Description
NON :
ODD:
EVEN:
OFF : ACK code is not returned.
ON : ACK code is returned.
ON :
OFF : Connector does not function.
ON : Connector functions.
OUT : The OUT connector is used.
39