Troubleshooting - Electrolux EHF3120FOK User Manual

www.electrolux.com
8
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metal-
lic discolorations. Use a special
cleaning agent for glass ceramic or
stainless steel.

6. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
The residual heat indica-
tor does not come on.
If you tried the above solutions and can-
not repair the problem, speak to your
dealer or the customer service. Give the
data from the rating plate, three digit letter
code for the glass ceramic (it is in the cor-
ner of the glass surface) and an error
message that comes on.
Make sure, you operated the appliance
correctly. If not the servicing by a custom-
er service technician or dealer will not be
free of charge, also during the warranty
Problem
2.
3.
Possible cause
The appliance is not con-
nected to an electrical
supply or it is connected
incorrectly.
Problem with the house
electrical system.
The cooking zone is not
hot because it operated
only for a short time.
period. The instructions about the cus-
tomer service and conditions of guarantee
are in the guarantee booklet.
6.1 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated be-
low:
Clean the appliance with a moist cloth
and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Check if the appliance is
correctly connected to
the electrical supply (refer
to connection diagram).
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Examine the fuse in the
electrical system of the
house in the fuse box. If
the fuses blow again and
again, speak to qualified
electrician.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.