Power Save Mode - Panasonic AG-DV2000P Operating Instructions Manual

Power Save Mode

1 Press MENU, and then select OPTION SETUP1.
2 Select POWER SAVE MODE.
3 Select OFF, 2H or 6H.
OFF: This setting does not conserve power when the
VCR is off.
2H: The VCR turns off automatically if no operation is
performed for approximately two hours.
6H: The VCR turns off automatically if no operation is
performed for approximately six hours.
4 Press MENU twice to exit the On Screen Display.
20
Wide Mode
1
On Screen Display
2 Select WIDE MODE.
3
4
To Set the Remote mode
1
2
3
4
Press MENU, and then select OPTION SETUP1.
Select OFF or S1.
OFF: When the S-Video input socket on the monitor
that is connected is an S-Video socket.
S1:
When the S-Video input socket on the monitor
that is connected is an S1 -Video socket.
(If a wide mode video signal is sent to the
monitor, the monitor screen size will automatically
switch to wide mode.)
Press MENU twice to exit the On Screen Display.
Press MENU, and then select OPTION SETUP1.
Select REMOTE MODE.
Select VCR1, VCR2 or VCR3.
This allows the remote controller to be set for operating
VCR1, VCR2 or VCRS.
When changing the remote control mode, press
VCR1 ,VCR2 or VCR3 while holding down POWER
to change the remote control mode of the remote
controller. If this is not done, it will not be possible to
operate the VCR using the remote controller.
Press MENU twice to exit the On Screen Display.