Dell PowerEdge R430 Owner's Manual page 188

f. memory modules
g. cooling shroud
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed through the cable routing latch.
4. Follow the procedure listed in the After working inside your system section.
5. Import your new or existing iDRAC Enterprise license. For more information, see the Integrated Dell
Remote Access Controller User's Guide at Dell.com/idracmanuals.
6. Ensure that you:
a. Use the Easy Restore feature to restore the service tag. See
the Easy Restore
b. If the Service Tag is not backed up in the backup flash device, enter the system service tag
manually. See
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). See
Initializing the TPM for TXT
Related Links
Safety instructions
Before working inside your system
Installing a processor
Installing a heat sink
Installing the integrated storage controller card
Installing the optional internal dual SD module
Replacing the optional internal USB memory key
Installing a cooling fan
Installing the optional iDRAC port card
Installing memory modules
Installing the expansion card riser
Installing the cooling shroud
After working inside your system
Restoring the Service Tag by using the Easy Restore feature
The Easy Restore feature enables you to restore your system's Service Tag, license, UEFI configuration,
and the system configuration data after replacing the system board. All data is automatically backed up in
a backup flash device. If BIOS detects a new system board and the Service Tag in the backup flash device,
BIOS prompts the user to restore the backup information.
1. Turn on the system.
If BIOS detects a new system board, and if the Service Tag is present in the backup flash device, BIOS
displays the Service Tag, the status of the license, and the UEFI Diagnostics version.
2. Perform one of the following steps:
After the restore process is complete, BIOS prompts to restore the system configuration data.
3. Perform one of the following steps:
• Press Y to restore the system configuration data.
• Press N to use the default configuration settings.
188
feature.
Entering the system Service Tag by using System
users.
Restoring the Service Tag by using
Setup.
Initializing the TPM for BitLocker users or