Dell PowerEdge R430 Owner's Manual page 15

Item Indicator, Button, or
Connector
4 USB management port
or iDRAC managed USB
port
5 USB port
6 Optical drive (optional)
7 LCD menu buttons
8 Information tag
9 LCD panel
10 Video connector
11 Hard drives
Icon Description
NOTE: To reset iDRAC using system ID,
ensure that the system ID button is enabled in
the iDRAC setup.
NOTE: If the system stops responding during
POST, press and hold the system ID button
(for more than five seconds) to enter the BIOS
progress mode.
The USB management port is USB 2.0 compliant.
Enables you to connect USB devices to the system
or provides access to the iDRAC Direct features.
For more information, see the Integrated Dell
Remote Access Controller User's Guide at
Dell.com/idracmanuals.
Use the USB 2.0 port to connect USB devices to
the system. This port is 4-pin, USB 2.0 compliant.
One optional slim SATA DVD-ROM drive or DVD
+/-RW drive.
Press the LCD menu buttons to navigate the
control panel LCD menu.
Displays system information such as service tag,
NIC, and MAC address.
NOTE: The information tag is a slide-out label
panel.
Displays system ID, status information, and system
error messages. For more information, see the LCD
panel section.
NOTE: LCD panel is not available in a cabled
hard drive system.
Use the video/VGA port to connect a display to the
system. For more information about the supported
video/VGA port, see the Technical specifications
section.
Up to 8 x 2.5-inch hard drives or SSDs.
For information about the supported hard drives,
see the Technical specifications section.
15