Power Interposer Board; Removing The Power Interposer Board - Dell PowerEdge R430 Owner's Manual

Figure 98. Installing the control panel module—eight hard-drive chassis
1. control panel module
3. control panel module connector cable
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
After working inside your system

Power interposer board

The power interposer board (PIB) is a board that connects the redundant power supply units (PSUs) to the
system board. The PIB is only supported in systems with redundant PSUs.

Removing the power interposer board

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: The power interposer board (PIB) is present only in systems that support redundant power
supply units (PSUs).
2. screw (2)
4. display module cable
181