Dell PowerEdge R430 Owner's Manual page 117

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
Steps
1. Align the two notches on the metal standoffs with the slots on the side of the optical drive.
2. Slide the optical drive into the notches until it is seated firmly and the release latch snaps into place.
3. Connect the power cable.
4. Connect the data cable to the back of the drive and to the SATA connector on the system board.
NOTE: Route and secure the cables using the cable routing latch on the system chassis to
prevent them from being pinched or crimped.
Figure 45.
1. optical drive
3. power cable
5. metal standoff (4)
Next steps
Follow the procedure listed in the After working inside your system section.
2. data cable
4. release latch
6. notch on the metal standoff (2)
117