Rinnai Sapphire Operating Information And Installation Instructions page 4

CUSTOMERS OPERATING INFORMATION
Press
the control
in the diagram.
There is no need
1. Ignition/Low
Medium
2.
H i g h
3.
FAN
The fan starts automatically when the heat exchanger has warmed up, this helps to prevent
cold draughts.
The fan speed is also controlled automatically; when the heater is set at low and medium
settings the fan runs at low speed, at the high setting the fan runs at high speed.
This gives the best combination of comfort and efficiency. When the heater is turned off
the fan will continue to run until the heat exchanger is cool, then
n
T0 DECREASE THE HEAT
This is simply done by releasing the control buttons in order from rear to front, to the re-
quired setting.
Press and release the buttons in order from back to front until all 3 buttons are in the "OFF"
(UP) position. The fan will stop when the heater cools off.
Ensure all burners are extinguished.
buttons in order from front to rear, this
to hold the buttons for 15 seconds when increasing the heat.
MJ/h
16
24 MJ/h
Buttons
will ignite additional burners as shown
Burner Pattern
stop automatically.